5.6 Brake assembly replacement
During the maintenance process after-service, if necessary, the brake may be supplied and replaced as assembly.
Working process:
- Based on part 5.1,take off the pad ;
- Take off the brake chamber according to part 5.5;
- Use box spanner to loosen the connecting bolt between the bracket and mounting board, remove the brake assembly;
- Check the disc and pad according to the requirement of part 4.3;
Installation:
- Remove the pad from the brake assembly according to the requirement of part 5.1;
- Install the brake across the disc on the axle, use spanner to tighten the bolt according to requirement;
- Install the pad and pad retainer etc. according to requirement of part 5.1;
- Install the air chamber according to the requirement of part 5.5;
Caution:
- Do not interchange the left and right brakes ;
- The arrow direction on the brake should be consistent with the rotation direction of the wheels
- Notice the tightening moment and mounting sequence ,while installing the connecting bolt between the bracket and mounting board;
- After installing the air chamber ,make sure that the water drain outlet face to the ground is open, and let the other outlets closed.